Can't "configure" libfilezflla
Posted: 2022-01-08 06:15
I carefully followed all the steps in https://wiki.filezilla-project.org/Comp ... nder_macOS. I downloaded all the components, including gmp-6.1.2, extracted them with tar, performed the ./configure, make and make install steps on all the components up to libfilezflla. When I did the ./configure on libfilezflla, I got the following:
checking whether pthread_condattr_setclock is declared... no
checking whether iconv can be used without link library... no
checking whether iconv needs -liconv... yes
checking for pkg-config... /Users/richard/prefix/bin/pkg-config
checking pkg-config is at least version 0.9.0... yes
checking for gmp... no
configure: error: gmplib was not found. You can get it from https://gmplib.org/
I checked with gmplib.org and they pointed out that version 6.1.2 needs to be compiled with XCODE 11.3 or later. So I made sure I had XCODE 11.3 and redid the gmplib steps, including make check. I still get the error shown above.
Looking in the src and prefix folders, I see lots of source files for gmp-6.1.2 and a few gmp files in prefix/lib and prefix/include, but no gmp files in prefix/bin.
I've been a professional programmer for 55 years, and a Mac owner since 1984 but this is my first foray into Mac development, so I'm at a complete loss as to how to figure out what the problem is.
checking whether pthread_condattr_setclock is declared... no
checking whether iconv can be used without link library... no
checking whether iconv needs -liconv... yes
checking for pkg-config... /Users/richard/prefix/bin/pkg-config
checking pkg-config is at least version 0.9.0... yes
checking for gmp... no
configure: error: gmplib was not found. You can get it from https://gmplib.org/
I checked with gmplib.org and they pointed out that version 6.1.2 needs to be compiled with XCODE 11.3 or later. So I made sure I had XCODE 11.3 and redid the gmplib steps, including make check. I still get the error shown above.
Looking in the src and prefix folders, I see lots of source files for gmp-6.1.2 and a few gmp files in prefix/lib and prefix/include, but no gmp files in prefix/bin.
I've been a professional programmer for 55 years, and a Mac owner since 1984 but this is my first foray into Mac development, so I'm at a complete loss as to how to figure out what the problem is.