Filezilla 2.2.5 installer program "dumps" on NT4?
Posted: 2004-03-26 18:47
I use filezilla since some time on NT4 and NT5 (win2000) computers.
Currently running 2.2.4f on NT4
I sucessfully installed new version 2.2.5 on Win2000 as usual,
but don't succeed to install it on 3 different NT4 machines.
The installation process on NT4 makes a dump "dr.watson user.dmp" early after the choice of the options to install.
I don't remember the details (code, address) but could look it up if necessary.
The 3 NT4 machines are all same hardware, an elder IBM300PL which is a bit old but good simple standard (S3 graphics etc.)
Two of them have same software (distribution of preconfigured NT4 by network admin), the third one is an individual standard installation of NT4 and SP6a without special extras, which I normally use as 2nd partition for repair activities and NTFS defrag purpose on partition 1.
As my simple standard NT4 fails 2.2.5 install too, I suppose that Filezilla has a more general problem with NT4.
Experiences from other users, or comments from developer welcome.
Thanks in advance.
Currently running 2.2.4f on NT4
I sucessfully installed new version 2.2.5 on Win2000 as usual,
but don't succeed to install it on 3 different NT4 machines.
The installation process on NT4 makes a dump "dr.watson user.dmp" early after the choice of the options to install.
I don't remember the details (code, address) but could look it up if necessary.
The 3 NT4 machines are all same hardware, an elder IBM300PL which is a bit old but good simple standard (S3 graphics etc.)
Two of them have same software (distribution of preconfigured NT4 by network admin), the third one is an individual standard installation of NT4 and SP6a without special extras, which I normally use as 2nd partition for repair activities and NTFS defrag purpose on partition 1.
As my simple standard NT4 fails 2.2.5 install too, I suppose that Filezilla has a more general problem with NT4.
Experiences from other users, or comments from developer welcome.
Thanks in advance.