Files upload to about 30% percent before 550 error

Need help with FileZilla Client? Something does not work as expected? In this forum you may find an answer.

Moderator: Project members

Post Reply
Message
Author
Cappo
500 Command not understood
Posts: 2
Joined: 2017-09-12 09:42
First name: Phil

Files upload to about 30% percent before 550 error

#1 Post by Cappo » 2017-09-12 10:00

Hi

I have tried to uplaod a file on 3 different pc's (1. server 2008 r2 Filezilla 3.27 No2. windows 10 64bit filezilla 3.27.1 No3. Windows 7 64bit filezilla 3.27.1) and also 3 different connections (LTE modem, Siax 1.5mb connection, and phone lte Hotspot) and have got the same problem at different stages of the upload each time i have tried. It Is as follows:
Command: TYPE I
Response: 200 Type set to I.
Command: PASV
Response: 227 Entering Passive Mode (154,73,2,130,206,109).
Command: LIST
Response: 150 Opening BINARY mode data connection.
Response: 226 Transfer complete.
Command: PASV
Response: 227 Entering Passive Mode (154,73,2,130,206,110).
Command: STOR Life in Christ EPS03,0.mp4
Error: Could not write to transfer socket: ECONNRESET - Connection reset by peer
Response: 550 The process cannot access the file because it is being used by another process.
Error: File transfer failed after transferring 1,048,576 bytes in 1 second
Status: Starting upload of C:\Users\Prayer house\Documents\prayer house\Life in Christ EPS03,0.mp4
Status: Retrieving directory listing of "/TBNinAfricaMedia"...
Command: PASV
Response: 227 Entering Passive Mode (154,73,2,130,206,111).
Command: LIST
Response: 125 Data connection already open; Transfer starting.
Response: 226 Transfer complete.
Command: PASV
Response: 227 Entering Passive Mode (154,73,2,130,206,112).
Command: STOR Life in Christ EPS03,0.mp4
Response: 550 The process cannot access the file because it is being used by another process.
Error: Critical file transfer error after transferring 1,048,576 bytes in 2 seconds
Status: Starting upload of C:\Users\Prayer house\Documents\prayer house\Life in Christ EPS03,0.mp4
Command: PASV
Response: 227 Entering Passive Mode (154,73,2,130,206,113).
Command: STOR Life in Christ EPS03,0.mp4
Response: 550 The process cannot access the file because it is being used by another process.
Error: Critical file transfer error
Status: Disconnected from server


Nothing is and was running other than filezilla each time. I have no clue what causes it to just stop the upload and say that is is being used by another process yet nothing else is running. Is there a solve to this?

User avatar
botg
Site Admin
Posts: 32472
Joined: 2004-02-23 20:49
First name: Tim
Last name: Kosse
Contact:

Re: Files upload to about 30% percent before 550 error

#2 Post by botg » 2017-09-12 10:53

Some process on the server still has the file opened. Please make sure no other process has opened the file on the server before uploading it.

Alternatively switch to a server that does not run Windows.

Cappo
500 Command not understood
Posts: 2
Joined: 2017-09-12 09:42
First name: Phil

Re: Files upload to about 30% percent before 550 error

#3 Post by Cappo » 2017-09-12 13:23

This process only opens the file 30% through or the last try 60% through? Then i can resume or write over or it tell file successful even when it obvious it isnt.

User avatar
boco
Contributor
Posts: 24786
Joined: 2006-05-01 03:28
Location: Germany

Re: Files upload to about 30% percent before 550 error

#4 Post by boco » 2017-10-25 11:56

A bit late, but...

Virus scanners and similar software can access the file at any time. For example, I had a strange issue with the avast A/V that interrupted downloads after 20000000 Bytes. Resuming or overwriting the file will not succeed until the A/V releases the file, again.
### BEGIN SIGNATURE BLOCK ###
No support requests per PM! You will NOT get any reply!!!
FTP connection problems? Do yourself a favor and read Network Configuration.
All FileZilla products fully support IPv6. http://worldipv6launch.org
### END SIGNATURE BLOCK ###

susan
500 Command not understood
Posts: 1
Joined: 2019-11-27 22:42

Re: Files upload to about 30% percent before 550 error

#5 Post by susan » 2019-11-27 22:48

Hi, I noticed that this post is kinda old,

I recently had the same problem - and I find that it can be easily solved if I rename my file to a different name, and then upload again, it will upload no problem.

Hope it works for others too.

Post Reply