Hello community,
I have been using FileZille 0.9x for ages and decided to upgrade to 1.61. Unfortunately, the setup didn't migrate the settings and after a couple of attempts I decided to start from scratch.
FileZilla is installed on a Windows server to access both local files and data located on Windows network shares. Accessing network shares worked fine in 0.9x. To do this, I granted a domain service account full control to the required shares and ran the FileZilla service under that service account. Because in the GUI I couldn't enter an UNC path, I edited the configuration file and restarted the service.
With 1.61 I can access to local files without a problem but I am getting error 550 for network shares. What I did:
Under "Rights Management", I entered the domain service account without domain.
As Local user:
1. Create user with password (Auth: Require a password to log in)
2. Disabled: "Use system credentials also for accessing files and directories" => So it should use the default system user (Service Account) that worked with 0.9x
3. Directories / => \\server\share (Service account has full permission to this share)
As Domain user
1. Create user (Auth: Use system credentails to log in)
2. Enabled: "Use system credentials also for accessing files and directories" => So it should use the domain user
3. Directories / => \\server\share => Domain user has full permission to this share
Update: Running FileZilla Service as service account seem to do the trick. However, two downsides:
1. Clicking a share takes from 1-20 seconds for the contents to show up (Disk spin-up is not the problem)
2. What is "Rights Management" for if the service accounts still needs to run under the service account?!
Cannot use network shares with 1.61 but in 0.9x
Moderator: Project members
-
- 500 Command not understood
- Posts: 2
- Joined: 2022-12-27 15:03
- First name: Christian
- Last name: van Haut