Error, could not connect to server
Posted: 2008-05-01 19:23
I set up FZ Server and it ran very nicely. I rebooted my computer and it's giving me this error over and over...
_____________________________
Reconnecting to server...
Error, could not connect to server
Trying to reconnect in 5 seconds
_____________________________
I use a D-LINK router with a Verizon DSL (Dynamic) connection.
Windows XP Professional
Norton Internet Security
FZ Server is setup to connect using IP 127.0.0.1:14147
Port forwarding on the router comes in two categories;
- Port Forwarding, allowing a network PC to be selected/entered (i.e. 192.168.0.100) and a Start port and End port and then selection of TCP/UDP/Any
- Application Rules, allowing a Trigger Port and seperate Firewall entry with TCP/UDP/Any selection as well
I went through the FAQ and the link in your sig and didn't see anything relating and also parused the forums. So if you would please, run me through the settings you recommend and any troubleshooting suggestions? Hopefully I can get this up and running by my deadline tonight!
_____________________________
Reconnecting to server...
Error, could not connect to server
Trying to reconnect in 5 seconds
_____________________________
I use a D-LINK router with a Verizon DSL (Dynamic) connection.
Windows XP Professional
Norton Internet Security
FZ Server is setup to connect using IP 127.0.0.1:14147
Port forwarding on the router comes in two categories;
- Port Forwarding, allowing a network PC to be selected/entered (i.e. 192.168.0.100) and a Start port and End port and then selection of TCP/UDP/Any
- Application Rules, allowing a Trigger Port and seperate Firewall entry with TCP/UDP/Any selection as well
I went through the FAQ and the link in your sig and didn't see anything relating and also parused the forums. So if you would please, run me through the settings you recommend and any troubleshooting suggestions? Hopefully I can get this up and running by my deadline tonight!